Water purification with UV lamps. UV systems can be used to disinfect water in a wide variety of applications including drinking water, wastewater, process water, swimming pools and ponds. UVC radiation is known to break the DNA of bacteria, viruses and spores. As a result, they are rendered harmless. UV radiation can be used for multiple purposes in water but is primarily employed as a disinfection process that inactivates micro-organisms without chemicals.
The quality of the water we drink has a profound effect on our health and well-being. Households can purify their water by installing UV water purification systems at the point of entry in the home, at the point of use (such as kitchen sink) or via separate purifiers.You can easily disinfect your rainwater & bore water before use. These UV systems are often combined with filters to remove other substances from the water (chlorine, particles). The benefits of UV disinfection are.
Effective for all types of microorganisms, including bacteria, viruses, fungi, and protozoa such as Cryptosporidium and Giardia. No disinfection by-products (DBPs) of health concern formed. Low capital and operating cost. Easy to operate and maintain. Does not change the taste of water.No overdose issues and the dose can be easily adapted to specific needs. Features of this Ultraviolet Water Treatment System.
This UV Water Steriliser is designed to suit a wide range of applications such as homes and apartments, hotels and resorts, restaurants, hospitals, schools, aquaculture, laboratories, swimming pools and ponds, community water supplies, agriculture etc. The Philips TUV lamp is based on proven technology that has allowed a breakthrough in lamp life reliability.
In contrast to other TUV lamps on the market, Philips TUV lamps contain two different electrodes. Because only one electrode determines the lifetime of the lamp, the causes for the spread in a lifetime are effectively halved and inherently better control of the lifetime spread is realised.As a result, the Philips TUV lamps outperform any other TUV lamp in their category on lifetime reliability. Kills 99.9% of bacteria. 55W Philips UV lamp with a lifespan of 8,700-hour. 304 Stainless Steel Housing (total length: 960mm).
LED operation light - which ensures you are in control 24/7. Inlet and Outlet: 3/4 (19.05mm) male thread. 200-240v to 55W electronic Ballast. 1- Unscrew the metal nuts on each end of the chamber. 2- Take the quartz sleeve out of its packaging and slide one of the two O-rings over one end of the quartz sleeve.3- Carefully slide the quartz sleeve into the chamber via the end with no O-ring and attach the second O-ring onto the end once it is in place. Then, screw the metal nuts back onto each end of the chamber. 4- Connect the lamp connector to the pins on the lamp. Slowly insert the UV lamp provided into the chamber through the hole of the aluminium nut end and secure the safety cap on the aluminium nut end. 5- Turn the water on once your set-up is complete and let the water flow through - opening the downstream tap to flush the unit for 1-2 minutes and Visually inspect for any leaks.
6- Turn on point of use to let water flow through the unit and wait for 2-3 minutes to release air and impurities from the system. 7- Plug in the power connector with ballast and make sure that the LED is illuminated steadily to start operation.Installation should be completed by qualified tradespersons only. Before attempting installation, check all components are intact and have not been damaged in transit. The UV water steriliser should be installed after any filtration or reverse osmosis systems.
In a pressurised system, the chamber can be installed horizontally or vertically. Determine an installation location remembering to allow the following clearances to the side of the unit for lamp changes (lamp exit and entry point can be determined by the installer). A power outlet is required. Avoid touching the quartz (glass) sleeve and lamp surface as marks and fingerprints may interfere with UV transmission. If the lamp is soiled, please clean the lamp with an alcohol-based cleaner. Avoid turning the lamp on and off unnecessarily as this will shorten the service life of the UV lamp. Turn off power to the UV when not using the system for an extended period of time. Flush the system when turning it back on. Risk Group 3 Ultra Violet product. The UV lamp emits high-power UV radiation that can cause severe injury to the skin and eyes.Avoid eye and skin exposure to unshielded products. Use only in an enclosed environment which shields users from the radiation. (please select from the above variation bar). 1x 304 Stainless Steel Housing. 1x 55W Philips UV lamp.
1x Power Supply (Electronic Ballast). We test/examine all the products before sent out. We will respond within 24 hours and do our best to help you out. This item is in the category "Home & Garden\Building Materials & DIY\Plumbing & Fixtures\Pumps & Water Filtration Systems\Water Filtration Systems". The seller is "cirex-store" and is located in this country: AU. This item can be shipped worldwide.